No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor 2200 V3 and 2600 V3 Storage System V300R005 SmartVirtualization Feature Guide 07

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Fujitsu DX80 S2/DX90 S2/DX410 S2/DX440 S2

Fujitsu DX80 S2/DX90 S2/DX410 S2/DX440 S2

This section introduces the configurations of Fujitsu DX80 S2/DX90 S2/DX410 S2/DX440 S2 that you need to pay attention to, when OceanStor 2200 V3/2600 V3 hosts a Fujitsu DX80 S2/DX90 S2/DX410 S2/DX440 S2 storage system.

  • When configuring the port mode, set Port Mode(After) to CA.

  • When configuring the port parameters, set the parameters to the values listed in the following figure.

    Connection

    • Configure the standard direct-connection network to FC-AL.
    • Configure the standard switch network to Fabric.

    Transfer Rate

    Auto-negotiation

    Reset Scope

    I_T_L

    Set Loop ID

    Auto

    Loop ID

    Ascending

    NOTE:

    As shown in the previous figure, you can set Frame Size and Release Reservation if Chip is Reset to any value.

  • When configuring the host parameters, set the parameters to the values listed in the following figure.

    Byte-0 of Inquiry Response

    No Conversion (Default)

    Inquiry VPD ID Type

    Type3 (Default)

    Inquiry Standard Data Version

    Version 5 (Default)

    Command Timeout Interval

    Default (25sec.)

    Load Balance Response

    Unit Attention (Default)

    Reservation Conflict Response For Test Unit Ready

    Normal (Default)

    Change Volume Mapping

    Report

    Volume Capacity Expansion

    Report

    Vendor Unique Sense Code

    Report

    Host Specific Mode

    Normal (Default)

    Asymmetric/Symmetric Logical Unit Access

    ACTIVE-ACTIVE/PREFERRED_PATH (Default)

    Sense Data Conversion

    No Conversion (Default)

NOTE:

For details about other parameters, see documentation of Fujitsu DX80 S2/DX90 S2/DX410 S2/DX440 S2.

Translation
Download
Updated: 2018-12-29

Document ID: EDOC1000106155

Views: 57437

Downloads: 143

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next