No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a Supercapacitor

Installing a Supercapacitor


Install a supercapacitor in any of the following scenarios:

  • A supercapacitor has failed.
  • A supercapacitor is low.



No special conditions are required for this operation.


No data preparation is required for this operation.


  • ESD gloves
  • Packaging materials, for example, an ESD bag
  • Phillips screwdriver


Spare supercapacitor


  1. Power off the physical partition where a supercapacitor is to be installed. For details, see Powering Off the 9016.
  2. Remove the front I/O module (FIO) where the supercapacitor is to be installed. For details, see Removing an FIO (FIO-A).
  3. Take the spare supercapacitor out of its ESD bag.
  4. Place the supercapacitor downwards and exert even force to install it in the tray. Ensure that the supercapacitor is secured by the plastic latches. See step (1) in Figure 6-89.
  5. Place the supercapacitor tray downwards in the chassis, and ensure that the tray edges are mounted on the edges of the chassis. See step (2) in Figure 6-89.
  6. Vertically insert the trans flash module (TFM) into the RAID controller card. See step (3) in Figure 6-89.

    Figure 6-89 Installing a supercapacitor

  7. Place the cover onto the FIO. See step (1) in Figure 6-90.
  8. Gently push the cover until it snaps into place. See step (2) in Figure 6-90.

    Figure 6-90 Installing an FIO cover

Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 104381

Downloads: 251

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next