No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing a RAID Controller Card (Switch Module)

Removing a RAID Controller Card (Switch Module)

Scenarios

Remove a RAID controller card from a switch module in any of the following scenarios:

  • A RAID controller card has failed.
  • A RAID controller card needs to be replaced with a new model.

Prerequisites

Conditions

No special condition is required for this operation.

Data

No data preparation is required for this operation.

Tools

  • ESD gloves
  • Packaging materials, for example, an ESD bag
  • Phillips screwdriver

Procedure

  1. Power off the entire SCE or REE where the RAID controller card to be removed is located. For details, see Powering Off the 9016.
  2. Remove the switch module. For details, see Removing a Switch Module.
  3. Press the button on the switch module cover. See step (1) in Figure 6-135.
  4. Remove the cover. See steps (2) and (3) in Figure 6-135.

    Figure 6-135 Removing the switch module cover

  5. Remove the air duct from the switch module. For details, see Removing an Air Duct.
  6. Loosen the screws on the supercapacitor, and remove the supercapacitor. See step (1) in Figure 6-136.
  7. Gently remove the RAID controller card. See step (2) in Figure 6-136.
  8. Place the removed RAID controller card in an ESD bag.

    Figure 6-136 Removing a RAID controller card

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 105681

Downloads: 253

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next