No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to the Server Over a Network Port by Using PuTTY

Logging In to the Server Over a Network Port by Using PuTTY

Scenarios

Using PuTTY, remotely log in to the server over a local area network (LAN) to configure and maintain the server.

Prerequisites

Conditions

A PC is properly connected to the management network port on the server by using a network cable.

Data

You have obtained the following data:

  • IP address of the server to be connected
  • User name and password for logging in to the server to be connected

Software

You can download PuTTY from chiark website. You are advised to use the latest version of PuTTY, otherwise you may fail to log in to the storage system.

Procedure

  1. Set the IP address and subnet mask or route information for the PC so that the PC can properly communicate with the server.

    On the PC, choose Start > Run, enter cmd in the text box, and press OK. On the CLI, run the Ping Server IP address command to check whether the PC can properly communicate with the server.

  2. Double-click Putty.exe.

    PuTTY starts, and the PuTTY Configuration window is displayed, as shown in Figure 9-7.

    Figure 9-7 PuTTY Configuration window

  3. Set the login parameters.

    For example, set the parameters as follows:

    • Host Name (or IP address): Enter the server IP address, for example, 192.168.2.8.
    • Port: Retain the default value 22.
    • Connection type: Retain the default value SSH.
    • Close window on exit: Retain the default value Only on clean exit.
    NOTE:

    After you set Host Name (or IP address) and then Saved Sessions and click Save, you can simply double-click the saved settings under Saved Sessions to log in to the server.

  4. Click Open.

    The PuTTY window is displayed. Then the message "login as:" is displayed, prompting you to enter a user name.

    NOTE:
    • If you log in to the server for the first time, the PuTTY Security Alert dialog box is displayed. Click Yes. The PuTTY window is displayed.
    • If the account entered during server login is incorrect, reconnect PuTTY.
  5. Enter the user name and password as prompted.

    After login, the host name of the server is displayed on the left of the prompt. See Figure 9-8.

Figure 9-8 Server host name displayed after successful login

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 103823

Downloads: 250

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next