No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing an FIO (FIO-B)

Removing an FIO (FIO-B)


Remove a front I/O module (FIO) in any of the following scenarios:

  • The FIO has failed.
  • A RAID controller card on the FIO has failed.
  • A supercapacitor on the FIO has failed.
  • A hard disk indicator panel has failed.
  • A hard disk backplane has failed.



No special conditions are required for this operation.


No data preparation is required for this operation.


  • ESD gloves
  • Packaging materials, for example, an ESD bag


  1. Power off the physical partition where the FIO is located. For details, see Powering Off the 9016.
  2. Fully open the FIO ejector levers. See step (1) in Figure 6-35.
  3. Gently remove the FIO by holding its ejector levers. See step (2) in Figure 6-35.
  4. Remove all modules from the FIO.

  5. Place the removed FIO in an ESD bag.

    Figure 6-35 Removing an FIO

Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 104155

Downloads: 251

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next