No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a Hot-Swappable PCIe Card

Installing a Hot-Swappable PCIe Card

Scenarios

Install a hot-swappable PCIe card on a BIO to replace a faulty one.

Prerequisites

Conditions

The support for hot swap of PCIe cards depends on the OS type. For details, see Server Compatibility Checker.

  • Only one hot-swappable PCIe card can be removed at a time.
  • The intervals between the removal and between the insertion of two PCIe cards must be longer than 20 seconds.

Data

No data preparation is required for this operation.

Tools

  • ESD gloves
  • Packaging materials, for example, an ESD bag

Hardware

Spare hot-swappable PCIe card

Procedure

  1. Take the spare hot-swappable PCIe card out of its ESD bag.
  2. Gently insert the hot-swappable PCIe card into the BIO in the REE as far as it will go. See Figure 6-146.

    Figure 6-146 Installing a hot-swappable PCIe card

  3. Determine the locations of the status indicator, power indicator, and hot swap button on the PCIe card. See Figure 6-147.
  4. Press the hot swap button below the PCIe card.
  5. Observe the power indicator on the PCIe card. Within 10 seconds (during which the power indicator is blinking), you can press the hot swap button again to cancel the hot insertion operation.

    Wait for at least 10 seconds until the power indicator is steady on, which indicates that the power supply to the PCIe card is normal.

    1

    PCIe card status indicator

    2

    PCIe card power indicator

    3

    PCIe card hot swap button

    Figure 6-147 Locations of the status indicator, power indicator, and hot swap button

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 103781

Downloads: 250

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next