Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing an NCM
Scenarios
Install a node controller module (NCM) to replace the faulty one.
Prerequisites
Conditions
No special conditions are required for this operation.
Data
No data preparation is required for this operation.
Tools
- ESD gloves
- Packaging materials, for example, an ESD bag
Hardware
Spare NCM
Procedure
- Power off the physical partition where an NCM is to be installed. For details, see Powering Off the 9016.
- Take the spare NCM out of its ESD bag.
- Insert the NCM into the SCE as far as it will go. See step (1) in Figure 6-42.
- Close the NCM ejector lever until the NCM is latched. See step (2) in Figure 6-42.
- Connect the node interconnect (NI) cables to the NCM. Install NI cables see Connecting NI Cables.