No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a RAID Controller Card (Switch Module)

Installing a RAID Controller Card (Switch Module)


Install a RAID controller card in a switch module in any of the following scenarios:

  • A RAID controller card has failed.
  • A RAID controller card needs to be replaced with a new model.



No special condition is required for this operation.


No data preparation is required for this operation.


  • ESD gloves
  • Packaging materials, for example, an ESD bag
  • Phillips screwdriver


Spare RAID controller card


  1. Power off the entire SCE or REE where a RAID controller card is to be installed. For details, see Powering Off the 9016.
  2. Remove the switch module. For details, see Removing a Switch Module.
  3. Remove the air duct from the switch module. For details, see Removing an Air Duct.
  4. Take the spare RAID controller card out of its ESD bag.
  5. Align the connector on the RAID controller card with the port on the mainboard, and gently insert the RAID controller card into the connector on the mainboard. See step (1) in Figure 6-137.
  6. Align the supercapacitor with the RAID control card, and tighten the screws. See step (2) in Figure 6-137.

    Figure 6-137 Installing the RAID controller card

  7. Place the cover onto the switch module. See step (1) in Figure 6-138.
  8. Gently push the cover until it snaps into place. See step (2) in Figure 6-138.

    Figure 6-138 Installing the switch module cover

Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 105680

Downloads: 253

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next