No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a Hot-Swappable PCIe Card

Installing a Hot-Swappable PCIe Card

Scenarios

Install a hot-swappable PCIe card on a back I/O module (BIO) to replace the faulty PCIe card.

PCIe cards of the same type must be installed in different SCEs to provide redundant configuration between SCEs.

Prerequisites

Conditions

The support for hot swap of PCIe cards depends on the operating system (OS) type. By default, the following OSs support hot swap of PCIe cards:

  • Windows
  • SUSE Linux Enterprise Server (SLES) 11 (A driver must be loaded.)
  • SLES 12
  • Red Hat Enterprise Linux (RHEL) 6 and 7
NOTE:

Only SLES and RHEL support hot swap of PCIe SSD cards.

Data

No data preparation is required for this operation.

Tools

  • ESD gloves
  • Packaging materials, for example, an ESD bag

Hardware

Spare hot-swappable PCIe card

Procedure

  1. Take the spare hot-swappable PCIe card out of its ESD bag.
  2. Gently insert the hot-swappable PCIe card into the BIO as far as it will go. See Figure 6-113.

    Figure 6-113 Installing a hot-swappable PCIe card

  3. Determine the locations of the status indicator, power indicator, and hot swap button on the PCIe card. See Figure 6-114.
  4. Press the hot swap button on the right of the PCIe card.
  5. Observe the power indicator on the PCIe card. Within 10 seconds during which the power indicator is blinking, you can press the hot swap button again to cancel the hot insertion operation.

    Wait for at least 10 seconds until the power indicator is steady on, which indicates that the power supply to the PCIe card is normal.

    1

    PCIe card status indicator

    2

    PCIe card power indicator

    3

    PCIe card hot swap button

    Figure 6-114 Locations of the status indicator, power indicator, and hot swap button

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 105327

Downloads: 251

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next