No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing a CPI

Removing a CPI

Scenarios

Remove a central partition interconnect module (CPI) if it has failed.

Prerequisites

Conditions

No special conditions are required for this operation.

Data

No data preparation is required for this operation.

Tools

  • ESD gloves
  • Packaging materials, for example, an ESD bag

Procedure

  1. Log in to the central management console (CMC) CLI. For details, see Logging In to the CMC CLI.
  2. Determine that the CPI to be removed is standby.

    • Run the smmget -l cpiN -d redundancy command to determine whether CPI 1 or 2 is standby.

      For example, if the value of N in the command is 1, standby in the command output (as shown in the following information) indicates that CPI 1 is standby, and active indicates that CPI 2 is standby.

      root@SMM:/# smmget -l cpi1 -d redundancy 
      The Redundancy State of CPI: 
      CPI1: Present(standby)     
    • Observe the ACT indicator of each CPI to determine whether the CPI is active or standby. If the ACT indicator is off, the CPI is standby. If the ACT indicator is steady green, the CPI is active.

  3. Run the smmset -l cpi -d hotswap -v 0 command to unload the CPI. When the system asks you whether to confirm the operation, enter y and press Enter.

    root@SMM:/# smmset -l cpi -d hotswap -v 0 
    Are you sure to unmount the backup cpi.Continue?[Y/N]:Y 
    Unmount the backup CPI success. 
    You can plug out the backup CPI now.

  4. Remove all cables from the CPI.
  5. Hold down the plastic latches on the outer sides of the CPI ejector levers. See step (1) in Figure 6-25.
  6. Fully open the CPI ejector levers. See step (2) in Figure 6-25.
  7. Gently remove the CPI by holding its ejector levers. See step (3) in Figure 6-25.
  8. Place the removed CPI in an ESD bag.

    Figure 6-25 Removing a CPI

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 87039

Downloads: 245

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next