No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing an NI Cable

Installing an NI Cable

Operation Scenario

Install a node interconnect (NI) cable to replace the faulty one or if it is not properly connected.



You have determined the cabinet number and location of the server where an NI cable is to be installed.

Before installing an NI cable, ensure that the service system is powered off to avoid equipment damage and personal injury due to an incorrect or loose connection.

Before installing the NI cable, ensure that the cable length is proper. For details about the cable specifications, see Table 2-43. For the cable connection, see Figure 3-64. If you can not determine the cable length, you are advised to bring a 1.5 m cable and a 2.3 m cable as spare parts.


No data preparation is required for this operation.


  • ESD gloves


  1. Take the spare NI cable out of its ESD bag.
  2. View the engineering label content of the NI cable, and note down the content in blank engineering labels.
  3. Attach the engineering labels to both ends of the NI cable.
  4. Remove the dustproof cap from the NI cable connector, align the cable connector with the port, and horizontally insert the connector into the port. See Figure 6-154.
    Figure 6-154 Installing an NI cable

  1. Push the NI cable connector inward and ensure that the cable is properly installed.

  1. After an NI cable is installed, attempt to pull it out gently. If the NI cable is securely connected, push the connector inward again to ensure that the connector is latched.
  2. After installing an NI cable, wait for 30 seconds before you power on the service system.
Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 105385

Downloads: 251

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next