No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Preparing for Installation

Preparing for Installation

Installation Environment Requirements

To ensure proper operating of the 9016, check the installation environment before beginning. The installation environment includes the space, cabinet, temperature, and humidity.

Installation Space Requirements

  • Install the server in an access-restricted area.
  • Keep the server area clean and tidy.
  • Keep a clearance of 800 mm (31.50 in.) from the front and rear doors of the cabinet to facilitate heat dissipation and device maintenance.

Cabinet Requirements

  • Use a common 19-inch cabinet that is more than 1000 mm (39.37 in.) deep and complies with the International Electrotechnical Commission 297 (IEC 297) standard.
  • Install air filters on the cabinet doors.
  • Provide AC power supply from the rear of the cabinet.

Temperature and Humidity Requirements

  • Regardless of climate or season, use temperature control devices.
  • In dry areas, mop the floor regularly or use a humidifier to increase humidity in the equipment room.
  • In humid areas, use a dehumidifier to decrease humidity in the equipment room.
Table 3-7 Temperature and humidity requirements




5°C to 40°C (41°F to 104°F)

The maximum operating temperature is 35°C (95°F) in case of a single fan module failure.


8% RH to 80% RH

Installation Rules

When installing a 9016, note the following:

  • A CME is 2 U high. You are advised to install the CME next to an SCE.
  • An SCE is 8 U high and heavy. Install the SCEs at the top and bottom of the cabinet for stability.
  • Install the REE below the SCE and leave 1U space between the SCE and the REE.
Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 103776

Downloads: 250

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next