No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing a Switch Module

Removing a Switch Module


Remove a switch module in any of the following scenarios:

  • The switch module has failed.
  • A RAID controller card has failed.
  • A hard disk backplane has failed.
  • A supercapacitor in the switch module has failed.
  • An air duct has failed.



No special condition is required for this operation.


No data preparation is required for this operation.


  • ESD gloves
  • Packaging materials, for example, an ESD bag


  1. Power off the physical partition where the switch module to be removed is located. For details, see Powering Off the 9016.
  2. Remove the front bezel and FPC. For details, see Removing a Front Bezel and Removing an FPC.
  3. Press the ejector release buttons on the switch module to eject the ejector levers. See step (1) in Figure 6-117.
  4. Fully raise the ejector levers. See step (2) in Figure 6-117.
  5. Gently remove the switch module by holding its ejector levers. See step (3) in Figure 6-117.
  6. Remove all modules from the switch module.

  7. Place the removed switch module in an ESD bag.

    Figure 6-117 Removing a switch module

Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 105356

Downloads: 251

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next