No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing an SCE

Removing an SCE


Remove a system compute enclosure (SCE) if the SCE or a component in the SCE has failed.



No special conditions are required for this operation.


No data preparation is required for this operation.


  • ESD gloves
  • Packaging materials, for example, an ESD bag
  • Phillips screwdriver


At least four persons are required to remove an SCE because it is heavy. Falling down of an SCE may cause equipment damage or personal injury.

  1. Turn off the switches on the PDUs corresponding to the system compute enclosure (SCE).
  2. Remove the front acoustic door. For details, see Removing an Acoustic Door.
  3. Remove all cables from the SCE.
  4. Remove all modules from the SCE.
  5. Loosen the captive screws that secure the rear mounting ear of the SCE. See step (1) in Figure 6-3.
  6. Remove the rear support. See step (2) in Figure 6-3.
    Figure 6-3 Removing a rear support

  7. Remove the protective covers on the four corners at the front of the SCE. See step (1) in Figure 6-4.
  8. Loosen the screws that secure the SCE. See step (2) in Figure 6-4.
  9. Gently remove the SCE. See step (3) in Figure 6-4.
  10. Place the removed SCE in an ESD bag.
    Figure 6-4 Removing an SCE

  11. Place the removed SCE in an ESD bag.
Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 104889

Downloads: 251

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next