No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing a PRM

Removing a PRM

Scenarios

Remove a PCIe riser module (PRM) in any of the following scenarios:

  • The PRM has failed.
  • A PCIe card on the PRM has failed.

Prerequisites

Conditions

No special conditions are required for this operation.

Data

No data preparation is required for this operation.

Tools

  • ESD gloves
  • Packaging materials, for example, an ESD bag
  • Phillips screwdriver

Procedure

  1. Power off the physical partition where the PRM is located. For details, see Powering Off the 9016.
  2. Remove the front I/O module (FIO) where the PRM is located. For details, see Removing an FIO (FIO-A).
  3. Press the button on the FIO cover. See step (1) in Figure 6-74.
  4. Remove the FIO cover. See step (2) in Figure 6-74.

    Figure 6-74 Removing an FIO cover

  5. Loosen the screws that secure the PRM. See step (1) in Figure 6-75.
  6. Press the latch in the arrow direction. See step (2) in Figure 6-75.
  7. Lift the ejector lever. See step (3) in Figure 6-75.
  8. Lift the PRM. See step (4) in Figure 6-75.
  9. Remove all PCIe cards from the PRM. For details, see Removing a PCIe Card from an FIO.
  10. Place the removed PRM in an ESD bag.

    Figure 6-75 Removing a PRM

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 75954

Downloads: 245

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next