No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Indicators and Buttons on the REE Rear Panel

Indicators and Buttons on the REE Rear Panel

Figure 2-51 shows the indicators and buttons on the REE rear panel.

Figure 2-51 Indicators and buttons on the REE rear panel

Table 2-35 describes the indicators and buttons.

Table 2-35 Indicators and buttons on the REE rear panel

No.

Silk Screen

Location

Indicator/Button

Color

Description

1

Each PCIe hot-swappable slot in a full-height hot swappable BIO

PCIe card status indicator

Yellow

  • On: The PCIe card is abnormal, or the server is in the power-on self-test (POST) phase.
  • Off: The PCIe card is operating properly.

2

Each PCIe hot-swappable slot in a full-height hot swappable BIO

PCIe card power indicator

Green

  • Steady green: The power supply to the PCIe card is normal.
  • Blinking green: The PCIe card is in the power-on or power-off process.
  • Off: The PCIe card is powered off.

3

Each PCIe hot-swappable slot in a full-height hot swappable BIO

PCIe card hot swap button

-

  • You can hot-swap the PCIe card when the system is operating properly.
  • Press this button when the PCIe card is operating properly. The PCIe card is removable 10 seconds after the PWR indicator turns off.
  • Press this button after you install a PCIe card. The PCIe card is operating properly 10 seconds later after the PWR indicator becomes steady green.

4

-

PSU

PSU status indicator

Green and orange

  • Steady green: The power supply and active MV12 output are normal.
  • Blinking green at 1 Hz:
    • The input is normal. The MV12 output is turned off due to INSTALLED.
    • The input is normal. The power supply enters the MV6 mode due to high PSON12V#.
    • The input is overvoltage or undervoltage.
    • Standby node in cold standby mode
    • Deep hibernation mode
  • Blinking green at 4 Hz: under online upgrade.
  • Steady orange: The input is normal, but no power output is supplied due to overheat protection, overcurrent protection, short circuit protection, output overvoltage protection, or some component failures.
  • Off: There is no AC input.
Translation
Download
Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 86938

Downloads: 245

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next