No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a PRM

Installing a PRM

Scenarios

Install a PCIe riser module (PRM) in any of the following scenarios:

  • A PRM has failed.
  • A PCIe card on a PRM has failed.

Prerequisites

Conditions

No special conditions are required for this operation.

Data

No data preparation is required for this operation.

Tools

  • ESD gloves
  • Packaging materials, for example, an ESD bag
  • Phillips screwdriver

Hardware

Spare PRM

Procedure

  1. Power off the physical partition where a PRM is to be installed. For details, see Powering Off the 9016.
  2. Remove the front I/O module (FIO) where the PRM is to be installed. For details, see Removing an FIO (FIO-A).
  3. Take the spare PRM out of its ESD bag.
  4. Install PCIe cards on the PRM. For details, see Installing a PCIe Card on an FIO.
  5. Insert the PRM into the FIO. See step (1) in Figure 6-76.
  6. Lower the ejector lever as far as it will go. See step (2) in Figure 6-76.
  7. Tighten the screws to secure the PRM. See step (3) in Figure 6-76.

    Figure 6-76 Installing a PRM

  8. Place the cover onto the FIO. See step (1) in Figure 6-77.
  9. Gently push the cover until it snaps into place. See step (2) in Figure 6-77.

    Figure 6-77 Installing an FIO cover

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 74662

Downloads: 245

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next