No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing a Hard Disk

Removing a Hard Disk

Scenarios

Remove a hard disk in any of the following scenarios:

  • The hard disk has failed.
  • The hard disk needs to be replaced with a new model.
  • The hard disk has no free space.

Prerequisites

Conditions

  • You do not need to power off the server when removing a hard disk.
  • You have backed up the data on the hard disk to be removed and deleted RAID configuration from the hard disk if services are running on the system compute enclosure (SCE) where the hard disk is located.

Data

No data preparation is required for this operation.

Tools

  • ESD gloves
  • Packaging materials, for example, an ESD bag

Procedure

  1. Press the button on the hard disk tray of the hard disk to be removed. The black handle automatically ejects. See step (1) in Figure 6-91.
  2. Hold the black handle and pull out the hard disk support. See step (2) in Figure 6-91.

    NOTE:

    The hard disk tray cannot completely pull out of the FIO.

    Figure 6-91 Removing a front hard disk tray

  3. Press the ejector release button on the hard disk. The ejector lever ejects automatically. See step (1) in Figure 6-92.
  4. Fully open the hard disk ejector lever. See step (2) in Figure 6-92.
  5. Pull out the hard disk for about 3 cm (1.18 in.) by holding the ejector lever. Wait for at least 30s until the hard disk stops spinning, and remove the hard disk from the front I/O module (FIO). See step (3) in Figure 6-92.
  6. Place the removed hard disk in an ESD bag.

    Figure 6-92 Removing a hard disk

Translation
Download
Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 103839

Downloads: 250

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next