No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing an SCE

Installing an SCE

Scenarios

Install a system compute enclosure (SCE) to replace the faulty one or after a component in the SCE is replaced.

Prerequisites

Conditions

No special conditions are required for this operation.

Data

No data preparation is required for this operation.

Tools

  • ESD gloves
  • Phillips screwdriver

Hardware

Spare SCE

Procedure

At least four persons are required to install an SCE because it is heavy. Falling down of an SCE may cause equipment damage or personal injury.

  1. Turn off the switches on the PDUs corresponding to the system compute enclosure (SCE).
  2. Take the spare SCE out of its ESD bag.
  3. Slide the SCE into the cabinet as far as it will go. See step (1) in Figure 6-5.
  4. Tighten the screws to secure the SCE. See step (2) in Figure 6-5.
  5. Install the protective covers on the four corners at the front of the SCE. See step (3) in Figure 6-5.
    Figure 6-5 Installing an SCE

  6. Place the rear support upward and slide rightwards. See step (1) in Figure 6-6.
  7. Tighten the captive screws that secure the rear support to the SCE. See step (2) in Figure 6-6.
    Figure 6-6 Installing a rear support

  8. Install all modules in the SCE.
  9. Connect all cables to the SCE.
  10. Install the front acoustic door. For details, see Installing an Acoustic Door.
Translation
Download
Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 99568

Downloads: 250

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next