No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


KunLun 9016 V100R001 User Guide 12

This document describes the appearance, specifications, parameters, and structure of the KunLun 9016, and how to install an OS, replace parts, and install, remove, configure, and troubleshoot the server.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Powering Off the 9016

Powering Off the 9016


Power off the 9016 in any of the following scenarios:

  • The 9016 needs to be maintained or replaced.

The method for powering off the 9016 varies according to scenarios. You can power off the server by pressing the system power button onsite or by using the central management console (CMC) CLI or WebUI remotely.

Impact on the System

Powering off the server stops the services and programs running on the server.



Before powering off a server, ensure that all services and programs on the server have been stopped or switched to another server.


  • All data has been backed up.
  • You have determined the cabinet number and installation position for the 9016 to be powered off.
  • You have obtained the IP address, user name, and password for the CMC management network port.


ESD wrist strap or ESD gloves


For details about how to obtain information about the CMC management network port and perform operations on the CMC, see KunLun Mission Critical Server V100R001 CMC User Guide.


  • Power off the server by holding down the system power button.

    Hold down the system power button on the front panel of the central management enclosure (CME) for 4 seconds. The service system of the server is forcibly powered off, but the CMC is still operating.


In physical partition mode, the system power button/indicator on the front panel of the CME is unavailable.

  • Power off the server by using the CMC CLI.
    1. Log in to the CMC CLI. For details, see Logging In to the CMC CLI.
    2. Run the smmset [-l smm] -d poweraction -v 2 partitionid command to remotely power off the server.

      In the command, partitionid indicates the ID of a physical partition. You can obtain the ID of each physical partition on the CMC WebUI.

  • Power off the server by using the CMC WebUI.
    1. Log in to the CMC CLI. For details, see Logging In to the CMC WebUI.
    2. On the CMC WebUI, choose Partition Management > KPAR.
    3. On the KPAR page, locate the physical partition to be powered off.
    4. Click Power Off.

      In the displayed dialog box, click OK. After the physical partition is powered off, its power indicator is steady yellow.

Updated: 2019-05-20

Document ID: EDOC1000111827

Views: 104459

Downloads: 251

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next