Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Restarting the Kbox Service
This topic describes running environment, restrictions, and loading process of the kbox.
Prerequisites
- The kbox is running properly in the EulerOS.
- The dump medium is working properly.
Loading Process
In the EulerOS that is running normally, log in to the system as a user with the root rights. Ensure that the configuration file is modified based on the requirements.
In the shell command line environment, run the following command in any path:
#systemctl restart kbox
Verifying Whether the Configuration File Is Successfully Loaded
When the system is shut down and then reboot, the kbox service is not interrupted. The systemctl stop kbox command is called when the system is shut down and reboot. The kbox service is not interrupted. The interface is null.
Run the following command to view the running status of the kbox:
#systemct status kbox
- If "active" is displayed, the kbox module is successfully loaded and running.
- If "active" is not displayed, the kbox module is not loaded or not successfully loaded. Check the kbox configuration file and parameters. Load the kbox module again after verification. For more information, see Troubleshooting of Common Faults.
