No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


KunLun Mission Critical Server V100R001 CMC Alarm Handling 09

This document describes KunLun 9016 and 9032 alarms in the CMC, in terms of their meanings, impact on the system, possible causes, and handling suggestions.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ALM-37000011 Incorrect NI Cable Connection

ALM-37000011 Incorrect NI Cable Connection


Alarm message:

Incorrect NI cable connection


Alarm ID

Alarm Severity

Auto Clear







Alarm Severity

Indicates the alarm severity.

Alarm Source

Indicates the alarm source.


Indicates the event body for which an alarm is generated.


Indicates the time when an alarm is generated.


Provides an alarm description.

Event Code

Indicates the event code of an alarm.

Impact on the System

The service system cannot be powered on.

Possible Causes

A node interconnect (NI) cable is not connected or not properly connected to the basic partition unit (BPU).


  1. Check whether an NI cable is connected to the BPU. For details, see the KunLun 90xx V100R001 User Guide.

  2. Connect an NI cable to the BPU. Then check whether the alarm is cleared.

    • If yes, no further action is required.
    • If no, go to Step 3.

  3. Check whether the NI cable is properly connected to the BPU.

  4. Remove and reconnect the NI cable. (For details, see the KunLun 90xx V100R001 User Guide.) Then check whether the alarm is cleared.

    • If yes, no further action is required.
    • If no, go to Step 5.

  5. Contact Huawei technical support.


After the fault is rectified, the system automatically clears the alarm.

Updated: 2018-12-29

Document ID: EDOC1000111849

Views: 116504

Downloads: 79

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next