Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Other BPU Alarms
- ALM-00000011 CPU Self-test Failed
- ALM-00000013 CPU Configuration Error
- ALM-23000029 Failed to Obtain the ID of an I/O Module
- ALM-2300002F REE Power Failure
- ALM-0300000F The Fan of a PSU Is Faulty
- ALM-03000013 iBMC Cannot Communicate with a PSU
- ALM-2C00000D No Memory Detected
- ALM-02000007 Disk Failure
- ALM-02000009 Disk Predictive Failure
- ALM-0200000B Disk RAID Array Is Invalid
- ALM-28000001 SAS or PCIe Cable Is Incorrectly Connected to the Disk Backplane
- ALM-04000007 Fan Failure
- ALM-04000005 Lost Fan Redundancy
- ALM-04000003 Fan Removed
- ALM-03000007 Lost Power Supply Redundancy
- ALM-1000000D Low Voltage of an RTC Battery on the Mainboard
- ALM-10000045 MOS FET Voltage Drop Exceeds the Threshold
- ALM-06000005 RAID Controller Card Failure
- ALM-01000015 Memory Configuration Error or Training Failed
- ALM-06000007 A RAID Controller Card Triggered an Uncorrectable Error
- ALM-08000001 A PCIe Card Triggered an Uncorrectable Error
- ALM-21000005 The RAID Array of SD Cards Is Invalid
- ALM-2100000B RAID Rebuild Failed at an SD Card
- ALM-2100000D SD Card Failure
- ALM-2100000F The SD Card Controller Failing to Detect Two SD Cards
- ALM-2C000031 Critical OS Error
- ALM-01000017 A DIMM Triggered an Uncorrectable Error
- ALM-0100000D Excessive Memory Correctable ECC
- ALM-0100002D Abnormal DIMM Health Status
- ALM-01000027 Memory Initialization Error
- ALM-01000025 Memory Configuration Error
- ALM-2C00004B Memory Configuration Error
- ALM-2C00004D Fatal Error Detected in Memory Initialization Check
- ALM-2C00004F No Memory Available
- ALM-0E000005 Memory Board SMI2 Link Initialization Error
- ALM-0000001D A CPU Triggered an Uncorrectable Error
- ALM-0D000001 A NIC Triggered an Uncorrectable Error
- ALM-27000003 The PCH Triggered an Uncorrectable Error
- ALM-32000001 Disk Backplane Expander Is Faulty
- ALM-05000001 Power Supply to the Disk Backplane Failed
- ALM-13000007 The NC Chip Bandwidth Is Decreased by 50% or the ECC Error Count Exceeding the Threshold
- ALM-13000009 A SEV2-level Error Occurred on the NC Chip
- ALM-28000007 CXP Cables Between NCMs Are Faulty, or Some Logical Links Are Disconnected
- ALM-28000009 All Logical Links of NI Cables Are Interrupted
- ALM-2900000B An NCM NI Port Is Disconnected
- ALM-2C000037 Different CPU Models Detected During System Startup
- ALM-2C000039 System Suspended During Startup
- ALM-12000013 Failed to Obtain Data of the Air Inlet Temperature
- ALM-10000063 Failed to Obtain the Voltage at 3.3 V Detection Point on the Mainboard
- ALM-10000065 Failed to Obtain the Voltage at 5 V Detection Point on the Mainboard
- ALM-10000067 Failed to Obtain the Voltage at 12 V Detection Point on the Mainboard
- ALM-10000069 Failed to Obtain the Voltage at the 1.1 V Detection Point on the Mainboard
- ALM-1000006B Failed to Obtain the Voltage at the 1.5 V Detection Point on the Mainboard
- ALM-1000006D Failed to Obtain the Voltage at the Standby 5 V Detection Point on the Mainboard
- ALM-1000006F Failed to Obtain the Voltage at the Standby 3.3 V Detection Point on the Mainboard
- ALM-10000075 Failed to Obtain the Voltage at the Standby 1.2 V Detection Point on the Mainboard
- ALM-10000071 Failed to Obtain the Voltage at Standby 2.5 V Detection Point
- ALM-10000073 Failed to Obtain the Voltage at Standby 1.5 V Detection Point
- ALM-10000077 Failed to Obtain the Voltage at Standby 1.1 V Detection Point
- ALM-10000079 Failed to Obtain the Voltage at Standby 1 V Detection Point
- ALM-0100001F Failed to Obtain Data of the CPU # DIMM VDDQ1 Voltage
- ALM-01000021 Failed to Obtain Data of the CPU # DIMM VDDQ2 Voltage
- ALM-2700000D Failed to Obtain Data of the PCH Voltage
- ALM-0000003B Failed to Obtain Data of the DTS Temperature for CPU #
- ALM-00000023 Failed to Obtain Data of the CPU Core Temperature
- ALM-23000013 Failed to Obtain Data of the 12 V Voltage for IO Board
- ALM-13000011 Failed to Obtain Data of the 12 V Voltage for NC Board
- ALM-08000007 Failed to Obtain the Electronic Label Data of the PCIe Card
- ALM-1000005F Soft-start Circuit Critical Fault
- ALM-24000003 Failed to Obtain Data of the CPU Temperature
- ALM-0600000D Failed to Obtain Data of the RAID Controller Card Temperature
- ALM-0600000F RAID Controller Card BBU Voltage Is Low
- ALM-06000011 RAID Controller Card BBU Is Faulty
- ALM-10000093 PS/2 or USB Keyboard Controller Error
- ALM-23000009 Failed to Obtain Temperature Data of the Right Part of the I/O Module Air Inlet
- ALM-2300000B Failed to Obtain Temperature Data of the Left Part of the I/O Module Air Inlet
- ALM-1300000B Failed to Obtain Data of the NC Chip Temperature
- ALM-2700000B Failed to Obtain Data of the PCH Temperature
- ALM-10000089 Failed to Obtain Electronic Label Data of the Mainboard
- ALM-1A000019 Abnormal Heartbeat Signal Between the Active and Standby iBMCs
- ALM-2800000B CPU QPI Link Degrade
- ALM-28000005 CPU QPI Link Failed
- ALM-39000001 Memory Board Configuration Error
- ALM-38000001 CPU Connected to JC Chip Has a VMSE Error
- ALM-2C000049 PSU Configuration Error
- ALM-0000002B CPU # iMC 0 Channel 0 Mirroring Failed
- ALM-0000002D CPU # iMC 0 Channel 1 Mirroring Failed
- ALM-0000002F CPU # iMC 0 Channel 2 Mirroring Failed
- ALM-00000031 CPU # iMC 0 Channel 3 Mirroring Failed
- ALM-00000033 CPU # iMC 1 Channel 0 Mirroring Failed
- ALM-00000035 CPU # iMC 1 Channel 1 Mirroring Failed
- ALM-00000037 CPU # iMC 1 Channel 2 Mirroring Failed
- ALM-00000039 CPU # iMC 1 Channel 3 Mirroring Failed
- ALM-2C000025 OS Is Forcibly Reset Due to Watchdog Timeout
- ALM-2C000027 OS Is Forcibly Powered off Due to Watchdog Timeout
- ALM-2C000029 OS Is Forcibly Powered off and then on Due to Watchdog Timeout
- ALM-28000003 CPLD Signal Cable Connection Exception
- ALM-3A000001 SD RAID Controller Fault
- ALM-23000011 I/O Module 12 V Undervoltage Major Alarm
- ALM-03000015 Output Overvoltage Detected on a PSU
- ALM-03000017 Output Undervoltage or No Output Detected
- ALM-03000019 Output Overcurrent Detected
- ALM-0300001B Input Overvoltage Detected
- ALM-3E000001 PCIe Switch Core Voltage Is Lower than the Undervoltage Threshold (Major Alarm)
- ALM-3E000003 PCIe Switch Core Voltage Exceeds the Overvoltage Threshold (Major Alarm)
- ALM-3E000005 Failed to Obtain Data of the PCIe Switch Core Voltage
- ALM-3E000015 PCIe Switch Temperature Exceeds the Overheating Threshold
- ALM-3E000017 Failed to Obtain the PCIe Switch Temperature
- ALM-3E000019 Failed to Obtain the PCIe Switch Upgrade File
- ALM-3E00001B PCIe Switch Upgrade Failure
- ALM-3E00001D Uncorrectable Error Occurs in the PCIe Switch (Major Alarm)
- ALM-14000001 Voltage for the Switch Module Exceeds the Overvoltage Threshold (Major Alarm)
- ALM-14000003 Voltage for the Switch Module Is Lower than the Undervoltage Threshold (Major Alarm)
- ALM-14000005 Failed to Obtain the Voltage for the Switch Module
- ALM-14000007 Abnormal Power Supply to the Clock Chips of the Switch Module (Major Alarm)
- ALM-14000009 Abnormal Clock Chips of the Switch Module (Major Alarm)
- ALM-1400000b Abnormal Power Signal of the Switch Module
- ALM-3F000001 Connection Board Is Not Properly Installed
- ALM-3F000003 Connection Board Is Not Detected
- ALM-3F000005 Connection Board Failure
- ALM-23000017 I/O Module Standby 3.3 V Overvoltage Major Alarm
- ALM-23000019 I/O Module Standby 3.3 V Undervoltage Major Alarm
- ALM-2300001B Failed to Obtain Standby 3.3 V Voltage for the I/O Module
- ALM-2300001D Abnormal Power Supply to the Clock Chips of the I/O Module (Major Alarm)
- ALM-2300001F Abnormal Clock Chips of the I/O Module (Major Alarm)
- ALM-23000021 Abnormal Power Signal of the I/O Module
- ALM-23000023 I/O Module VCC 3.3 V Overvoltage Major Alarm
- ALM-23000025 I/O Module VCC 3.3 V Undervoltage Major Alarm
- ALM-14000027 Failed to Obtain VCC 3.3 V Voltage for the I/O Module
- ALM-13000041 Failed to Configure CDR for the NCM
- ALM-3700003B VNC Certificate Expiring
- ALM-3700003D VNC Certificate Expired
- ALM-1700007f CMC EEPROM Selftest Failed
- ALM-33000027 Failed to Obtain Data of the CPI 12 V Soft-start Circuit
- ALM-35000019 Failed to Obtain Data of the CIM 12 V Soft-start Circuit
- ALM-3700003F CPI Clock Configuration Failure
- ALM-10000061 Video Controller Error
- ALM-10000093 PS/2 or USB Keyboard Controller Error
- ALM-2C000065 Number of RAID Controller Cards Does Not Match the Product Model
- ALM-00000083 Insufficient PCIe MMIO Resources (Critical Alarm)
Previous
