No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S1720GFR, S2700, S5700, and S6720 V200R010C00 Web-based Configuration Guide

This document describes the configuration and maintenance of device through the web network management system. The web network management system provides the functions of viewing device information and managing the entire system, interfaces, services, ACL, QoS, routes, security, and tools.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example of Configuring a DHCP Server Based on a VLANIF Interface Address Pool

Example of Configuring a DHCP Server Based on a VLANIF Interface Address Pool

Networking Requirements

As shown in Figure 2-315, the switch functions as a DHCP server to uniformly assign IP addresses to the hosts in the office of an enterprise. The office belongs to the network segment 10.1.1.0/24, all the hosts are added to VLAN 10, and the DNS and NetBIOS services are used in the office. The DNS server address is 10.1.1.2 and NetBIOS server address is 10.1.1.3.

Figure 2-315  Networking diagram for configuring a DHCP server based on a VLANIF interface address pool

Configuration Description

Before configuring a DHCP server based on a VLANIF interface address pool, you must perform the following operations in sequence:
  1. Add GE0/0/1 to VLAN 10.
  2. Configure an IP address for VLANIF 10.

For detailed VLAN configuration operations, see VLAN.

Procedure

  1. Choose Service Management > DHCP > DHCP in the navigation tree to display the DHCP page.
  2. Select Enabled for DHCP, as shown in Figure 2-316.

    Figure 2-316  Enabling DHCP

  3. Click Apply.
  4. Choose Service Management > DHCP > Configure VLANIF Interface Address Pool in the navigation tree to display the Configure VLANIF Interface Address Pool page, as shown in Figure 2-317.

    Figure 2-317  Configure VLANIF Interface Address Pool page

  5. Click Create to display the Create a VLANIF Address Pool page.
  6. Set the following parameters, as shown in Figure 2-318.

    • Select Vlanif10 from the VLANIF name drop-down list box.
    • Select interface for Address pool type.
    • Add 10.1.1.2 as Forbidden IP.
    • Add 10.1.1.3 as Forbidden IP.
    • Add text as Client domain name.
    • Add 10.1.1.2 as DNS server IP.
    • Add b-node as NetBIOS node type.
    • Add 10.1.1.3 as NetBIOS server IP.
    Figure 2-318  Configuring the VLANIF interface address pool

  7. Click OK.
  8. Click in the navigation tree.

Result

The configuration is displayed on the Configure VLANIF Interface Address Pool page, as shown in Figure 2-319.

Figure 2-319  VLANIF interface address pool configuration
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000114003

Views: 50398

Downloads: 1057

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next