No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S1720GFR, S2700, S5700, and S6720 V200R010C00 Web-based Configuration Guide

This document describes the configuration and maintenance of device through the web network management system. The web network management system provides the functions of viewing device information and managing the entire system, interfaces, services, ACL, QoS, routes, security, and tools.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).


This subnode provides information about the device panel.


The panel area on the Web system page displays information about each port of the selected switch, including:
  • Number of ports
  • Operating mode of each port

You can place the cursor on a port to view the ID, type, rate, and status of the port.


  1. To view the panel of a non-stacked device, click Device Summary in the navigation tree to open the Device Summary page.

    The device panel is displayed on the page, as shown in Figure 2-21.

    Figure 2-21  Panel

  2. To view the panel of a stacked device, click Device Summary in the navigation tree to open the Device Summary page. The stack topology is displayed on the page, as shown in Figure 2-22. Click the slot ID of a device to display the Board Information, as shown in Figure 2-21.

    Figure 2-22  Stack topology

  3. Select a refresh interval from the drop-down list before Refresh. The value Manual indicates not refresh. The default interval is 60 seconds.
  4. Click Refresh. Then the Web system synchronizes data with the switch and refreshes the information on the page.
  5. If you click a port icon, the configuration information of each port is displayed, as shown in Figure 2-23.

    Figure 2-23  Detailed information about an interface

Updated: 2019-08-21

Document ID: EDOC1000114003

Views: 50519

Downloads: 1059

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next