No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S1720GFR, S2700, S5700, and S6720 V200R010C00 Web-based Configuration Guide

This document describes the configuration and maintenance of device through the web network management system. The web network management system provides the functions of viewing device information and managing the entire system, interfaces, services, ACL, QoS, routes, security, and tools.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Establishing a Stack Using Service Port Connections

Example for Establishing a Stack Using Service Port Connections

Networking Requirements

As shown in Figure 2-247, SwitchA, SwitchB, and SwitchC need to set up a stack with a ring topology. SwitchA, SwitchB, and SwitchC are the master, standby, and slave switches, respectively, with stack IDs of 0, 1, and 2 and stack priorities of 200, 100, and 100. They function as one logical device on the network, therefore increasing the number of ports and simplifying network management and maintenance.

The S5700-X-LI series switches are used on the network to set up a stack.

Figure 2-247  Stack networking

Configuration Roadmap

SwitchA, SwitchB, and SwitchC start as a single system, without the configuration of any logical stack interface or physical stack interface. Switches are connected through SFP+ stack cables according to Figure 2-247.

Configure SwitchA, SwitchB, and SwitchC in sequence.

  1. Configure stack IDs and stack priorities.

  2. Configure stack ports.

Procedure

  1. Configure stack IDs and stack priorities.
    1. In the navigation tree, choose System Management > Stacking. The Stacking page is displayed, as shown in Figure 2-248.

      Figure 2-248  Stacking

    2. Click icon. The Configure Stack Parameters page is displayed, as shown in Figure 2-249.

      Figure 2-249  Configure Stack Parameters

    3. Refer to the following table to set stack parameters.

      Table 2-142  Setting stack parameters

      Device

      Next Stack ID

      Next Startup Priority

      SwitchA

      0

      200

      SwitchB

      1

      100

      SwitchC

      2

      100

    4. Click OK. The configuration is complete.
  2. Configure stack ports.
    1. Click a switch in the role list. The physical stack interfaces on the switch are displayed in the logical interface list, as shown in Figure 2-250.

      Figure 2-250  Logical interface list

    2. Click icon. The Configure Stack Interface page is displayed, as shown in Figure 2-251.

      Figure 2-251  Configure Stack Interface

    3. Select an interface to serve as a physical stack interface.
    4. Click OK. The configuration is complete.
    5. On the Stacking page, click Apply. A dialog box is displayed, indicating that the configuration takes effect only after the device is restarted. Click OK. The configuration is complete.
Translation
Download
Updated: 2019-08-21

Document ID: EDOC1000114003

Views: 51820

Downloads: 1065

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next