No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S1720GFR, S2700, S5700, and S6720 V200R010C00 Web-based Configuration Guide

This document describes the configuration and maintenance of device through the web network management system. The web network management system provides the functions of viewing device information and managing the entire system, interfaces, services, ACL, QoS, routes, security, and tools.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).


You can specify the system software, configuration file, and patch file loaded to the switch at next startup.


The specified configuration file takes effect at next startup. Ensure that the configuration data is saved on the device before the reboot.

During the reboot, you are disconnected from the switch. If you have not saved the configuration data, the configuration data will be lost after the reboot. Therefore, save the configuration before you reboot the system.

The system software and configuration file are for reference only. The actual output information may differ from the preceding information.


  1. Choose System Management > Reboot in the navigation tree to open the Reboot page, as shown in Figure 2-46.

    Figure 2-46  Reboot

    Table 2-16 describes the parameters on the Reboot page.
    Table 2-16  Reboot



    System software

    Specifies the system software for next startup.

    Configuration file

    Specifies the configuration file for next startup.

    Patch file

    Specifies the patch file for next startup.

  2. Select desired options from the drop-down lists and click Reboot. A pop-up dialog box is displayed, notifying you that communication between the system and the device will be interrupted during the reboot.
  3. Click Yes in the displayed dialog box. A dialog box is displayed to prompt you to save the configuration.
  4. Click Save. The system will reboot and save the configurations.

    If you click Ignore, the switch will reboot, but unsaved configurations will be lost. When switching the device's configuration file, click Ignore; otherwise, configuration file switching fails.

Updated: 2019-08-21

Document ID: EDOC1000114003

Views: 46854

Downloads: 1041

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next