No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S2700, S3700, S5700, S6700, S7700, and S9700 Series Switches Interoperation and Replacement Guide

This document provides typical configuration examples for interoperation between Huawei switches and mainstream IP phones, firewalls, routers, Microsoft NLB servers, multi-NIC servers, Cisco switches, and SolarWinds.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Interoperation and Replacement Solution for LNP and DTP

Interoperation and Replacement Solution for LNP and DTP

DTP and LNP are both proprietary protocols, so they cannot interwork. The two protocols can replace each other. Select either of the following solutions depending on the actual scenario:
  • Network-wide replacement: All Cisco DTP switches are replaced by Huawei switches that support LNP.
  • Single replacement: One Cisco switch is replaced by a Huawei S series switch. The remote switch is still a Cisco switch. In this situation, you need to configure the interface of the remote Cisco switch to work in non-negotiation mode.
Translation
Download
Updated: 2019-05-15

Document ID: EDOC1000114005

Views: 179027

Downloads: 8164

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next