No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S2700, S3700, S5700, S6700, S7700, and S9700 Series Switches Interoperation and Replacement Guide

This document provides typical configuration examples for interoperation between Huawei switches and mainstream IP phones, firewalls, routers, Microsoft NLB servers, multi-NIC servers, Cisco switches, and SolarWinds.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Comparison Between HSRP and VRRP

Comparison Between HSRP and VRRP

Comparison Between HSRP and VRRP Parameters

Table 5-17  Comparison between HSRP and VRRP parameters

Parameter

HSRP

VRRP

Standards compliance

Cisco proprietary protocol with low protocol compliance

Standard protocol with high protocol compliance

Destination MAC address of protocol packets

00-00-0c-07-ac-Group_ID

00-00-5e-00-01-VRID

Destination IP address of protocol packets

224.0.0.2

224.0.0.18

TTL

1

255

Encapsulation mode

Encapsulated in UDP packets, port number 1985

Encapsulated in IP packets

Default interval for sending Hello messages

Sending interval: 3s, timeout interval: 9s

Sending interval: 1s, timeout interval: 3s

Association with an interface

Supported

Supported

Protocol state machine

Initial, Learn, Listen, Speak, Standby, Active

Initialize, Master, Backup

Comparison Between HSRP and VRRP Commands

Table 5-18  Comparison between HSRP and VRRP commands

Function

HSRP Command

VRRP Command

Configure a standby group.

standby group-number ip virtual-ip-address

vrrp vrid virtual-router-id virtual-ip virtual-address

Configure the priority for a standby group.

standby group-number priority priority-value

vrrp vrid virtual-router-id priority priority-value

Configure the preemption mode.

standby group-number Preempt

vrrp vrid virtual-router-id preempt-mode disable

Configure the Hello message timer.

standby group-number timers hellotime holdtime

vrrp vrid virtual-router-id timer advertise advertise-interval

Display the configuration of a standby group.

show standby vlan vlan-number

show standby brief

show standby all

debug standby

display vrrp brief

debugging vrrp4 state interface interface-type interface-number vrid virtual-router-id

debugging vrrp4 packet interface interface-type interface-number vrid virtual-router-id [ verbose ]

debugging vrrp4 timer interface interface-type interface-number vrid virtual-router-id

Configure association with interfaces.

standby group-number track type number interface-priority

vrrp vrid virtual-router-id track interface interface-type interface-number [ increased value-increased | reduced value-reduced ]

Translation
Download
Updated: 2019-05-15

Document ID: EDOC1000114005

Views: 179298

Downloads: 8164

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next