No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

OceanStor 9000 V300R006C00 File System Feature Guide 12

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Storage Devices

Configuring Storage Devices

This section explains how to configure the parameters of the alarm connection protocol so that the OceanStor 9000 can report alarms to eSight.

Prerequisites

eSight can communicate with the management network of the OceanStor 9000 cluster through a route (eSight and the cluster can ping each other).

If the OceanStor 9000 cluster has C72 nodes, eSight must reside on the same subnet as the management network of the OceanStor 9000 cluster and Layer 2 interconnection is required.

Procedure

  1. Log in to the CLI. For details, see section Logging In to the CLI in the OceanStor 9000 Command Reference.
  2. Run the add snmp usm command to add SNMP security users.

    admin:/>add snmp usm testuser ReadWrite SHA AES
    Please enter your authentication password:**********
    Please enter your authentication password again:**********
    Please input your private password:***********
    Please input your private password again:***********
    Command executed successfully.

  3. Run change snmp status start to enable the SNMP function.

    The SNMP agent service is disabled by default.

  4. Wait about 10 seconds then run show snmp status, check the status of SNMP function. Running status indicate that the status is normal.
  5. Run show snmp usm to view the user.

    admin:/>show snmp status 
                   
      Controller  Name  Status   Memory      CPU(%)  
      ----------  ----  -------  ----------  ------  
      26133       SNMP  Stopped     0.000KB  0       
      26137       SNMP  Stopped     0.000KB  0       
      26143       SNMP  Stopped     0.000KB  0       
      26147       SNMP  Running     0.000KB  1       
    admin:/>show snmp usm    
    
      ID  User Name  User Level  Authenticate Protocol  Private Protocol  
      --  ---------  ----------  ---------------------  ----------------  
      0   testuser        ReadWrite   SHA                    AES     

Translation
Download
Updated: 2019-06-27

Document ID: EDOC1000122519

Views: 85603

Downloads: 151

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next