Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Dedicated Stack Cable
Types of Dedicated Stack Cables
Table 4-8 lists the applicable dedicated stack cables.
Appearance and Structure
Figure 4-18 Dedicated stack cable appearance
![]()
Each dedicated stack cable has a Master tag on one end, and the untagged end is the slave end.
Figure 4-19 shows the structure of a dedicated stack cable.
Stack Setup
Dedicated stack cables can only be used to connect the same sub-series switch models, enabling them to set up a stack without manual configuration.
Before setting up a stack, confirm the stack connection mode supported by the member switches, as well as the hardware and software requirements. For details, see "Determining the Stack Connection Support and Mode" under "Typical Stack Configuration of Fixed Switches" in the Typical Configuration Examples.
