No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 2800 V3 V300R006

This document is applicable to OceanStor 2800 V3. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



The rebootsystem command is used to reset the controller operating system through CPLD in the controller's SES serial port mode.


rebootsystem resettype






Type of restarting the storage system.

The values are described as follows:

  • "0": soft reset.
  • "1": hard reset.

A hexadecimal value is also supported.


serial port mode

Usage Guidelines

  • This command can only be executed on devices integrating disks and controllers.
  • The "rebootsystem 0" command is used to set the soft reset of the operating system.
  • The "rebootsystem 1" command is used to set the hard reset of the operating system.
  • After this command is executed, check whether to continue the reset operation as prompted. If you select "y", enter the serial port login password to complete the reset operation as prompted. If you select "n", you will exit without performing the reset operation.
  • Running this command is a highly risky operation. Execute this command with caution when there are ongoing services because this command may interrupt services.


Run the "rebootsystem 0" command to restart the storage system in soft reset mode.

PANREA_SES:>rebootsystem 0 
DANGER: You are about to restart storage system. This may take several minutes. This operation will interrupt all services on the storage system. 
Suggestion: Before performing this operation, stop all services on the system. 
Have you read danger alert message carefully?(y/n)y 

Are you sure you really want to perform the operation?(y/n)y 
Command executed successfully.

System Response


Updated: 2019-07-12

Document ID: EDOC1000138381

Views: 753351

Downloads: 38

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next