No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 2800 V3 V300R006

This document is applicable to OceanStor 2800 V3. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
upgrade disk_convertor

upgrade disk_convertor

Function

The upgrade disk_convertor command is used to upgrade disk converters.

Format

upgrade disk_convertor [ disk_id=? ]

Parameters

Parameter

Description

Value

disk_id=?

Disk ID in "enclosure.slot" format.

To obtain the value, run "show disk general" without parameter.

Views

Developer view

Usage Guidelines

  • To upgrade all disk converters, run "upgrade disk_convertor".
  • To upgrade a specific disk converter, run "upgrade disk_convertor disk_id=?".

Example

Batch upgrade disk converters.

developer:/>upgrade disk_convertor 
DANGER: You are going to upgrade the firmware of the disk converter. This operation causes the hard disk to be unavailable for about 5 minutes to 60 minutes depend on the number of the disk need to be upgraded. Please make sure to stop all services and repair all alarms before performing this operation. Please don`t interrupt the power supply during the upgrade. 
If a fault occurs during the upgrade, the upgraded hard disk becomes unavailable. 
Suggestion: After the upgrade is completed, run the poweroffsys command to power off the system and then power on the system again for the upgraded firmware to take effect. 
Have you read danger alert message carefully?(y/n) 
y 
Are you sure to perform this operation?(y/n) 
y 
Command executed successfully

System Response

None

Translation
Download
Updated: 2019-07-12

Document ID: EDOC1000138381

Views: 752007

Downloads: 38

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next