No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 2800 V3 V300R006

This document is applicable to OceanStor 2800 V3. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change vlan_offload state

change vlan_offload state

Function

The change vlan_offload state command is used to enable or disable the VLAN offload function, and set the automatic configuration function.

Format

change vlan_offload state eth_port_id=? switch=?

Parameters

Parameter

Description

Value

eth_port_id

ID of ETH port.

To obtain the value, run "show port general physical_type=ETH".

switch

Switch used to set the VLAN offload function on an ETH physical port of a single IOC card.

The value is "off", "on", or "auto", where:

  • "off": disables the VLAN offload function on an ETH physical port of an IOC card.
  • "on": enables the VLAN offload function on an ETH physical port of an IOC card.
  • "auto": allows the system to automatically determine whether to enable or disable the VLAN offload function.

Views

Developer view

Usage Guidelines

  • The switch supports dynamic configuration. You are advised to use the dynamic configuration when no services are running on the port. If you set the switch when the services are running, performance may decrease for a short time.
  • The switch is mainly used to configure VLAN services. By default, the switch is in "auto" state and the system will determine whether to enable or disable the VLAN offload function.
  • If you enable the VLAN offload function, the FCoE function cannot be used. The FCoE service and the service configure with a VLAN are not supported to run in the same port.
  • The switch is set for the single ETH physical port of an IOC card.
  • The following cards support the switch: SmartIO card (SmartIO interface card and SmartIO onboard card) and 10GE electrical port card of IOC.
  • If the FCoE function is not supported due to the VLAN offload function, you can set the switch status to "off" for the ports to run FCoE services.

Example

Set the function of offloading the ETH single-port VLAN.

developer:/>change vlan_offload state eth_port_id=CTE0.A.IOM0.P0 switch=on 
CAUTION: 1. Before performing this operation, confirm that the operating system type of the host to be created is the same as that of the service host. 
2. If the operating system of the service host is Windows, and all thin LUN functions are required to get better experience, select Windows Server 2012. 
Suggestion: Confirm again that the correct operating system type has been specified. 
Do you wish to continue?(y/n)y 
Command executed successfully.

System Response

None

Translation
Download
Updated: 2019-07-12

Document ID: EDOC1000138381

Views: 660516

Downloads: 36

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next