No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 2800 V3 V300R006

This document is applicable to OceanStor 2800 V3. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change protocol debug

change protocol debug


The change protocol debug command is used to enable or disable the debug log.


change protocol debug name=? enabled=? [ controller=? ]






Protocol name.

The value can be "ftp", "http", or "ndmp".

  • "ftp": FTP protocol.
  • "http": HTTP protocol.
  • "ndmp": NDMP protocol.


Whether to enable.

The value can be "yes" or "no".

  • "yes": enables the debug log.
  • "no": disables the debug log.


Indicates the controller ID.

The value is in the format of "XA" or "XB" or "XC" or "XD", where the "X" is an integer ranging from 0 to 3, for example: "0A", "1C".


Developer view

Usage Guidelines



  • Enable the debug log for FTP.
    developer:/>change protocol debug name=ftp enabled=yes 
    CAUTION: You are about to open the protocol debug. This operation may cause the log to be partially covered, and a large amount of printing degrades the performance.  
    Suggestion: Confirm whether the protocol debug log is required to be opened. 
    Do you wish to continue?(y/n)y 
    Command executed successfully.
  • Disable the debug log for NDMP.
    developer:/>change protocol debug name=ndmp enabled=no 
    Command executed successfully.

System Response


Updated: 2019-07-12

Document ID: EDOC1000138381

Views: 723560

Downloads: 36

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next