No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 2800 V3 V300R006

This document is applicable to OceanStor 2800 V3. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
cliset -t fan -d

cliset -t fan -d

Function

The cliset -t fan -d command is used to set the working mode and speed level of fans, and simulate fan faults.

Format

cliset -t fan -d dataitem -v parameter

Parameters

Parameter

Description

Value

dataitem

Type of fan information.

The value can be "mode", "level", "run", or "simubad", where:

  • "mode": mode.
  • "level": speed level.
  • "run": fan status.
  • "simubad": simulated fault.

parameter

Command parameter.

  • When dataitem is "mode", the value can be "0" or "1", where:
    • "0": automatic.
    • "1": manual.
  • When dataitem is "level", the value is "fanid" or "level", where "fanid" ranges from 0 to 5 and "level" ranges from 1 to 32.
  • When dataitem is "run", the value can be "0" or "1", where:
    • "0": The fan is shut down.
    • "1": The fan is turned on.
  • When dataitem is "simubad", the value is "fanid", "start", "rate", or "sign", where
    • "fanid": The value ranges from 0 to 5.
    • "start": The value can be "0" or "1". "0" indicates that simulation stops. "1" indicates that simulation starts.
    • "rate": The value ranges from 0 to 3. "0" indicates 100%. "1" indicates 50%. "2" indicates 25%. "3" indicates 10%.
    • "sign" can be "0" or "1". "0" indicates positive deviation. "1" indicates negative deviation.

Modes

serial port mode

Usage Guidelines

None

Example

  • Setting the working mode of the fan to manual.
    administrator@CTRL_B / $ cliset -t fan -d mode -v 1 
    Set fan mode successfully.
  • Setting the speed level of fans in group 0 to 8.
    administrator@CTRL_B / $ cliset -t fan -d level -v 0 8 
    Set fan level successfully!
  • Turning on a fan.
    administrator@CTRL_B / $ cliset -t fan -d run -v 1 
    Set fan run successfully.
  • Simulating the fault that the speed of fan 0 decreases by 25%.
    administrator@CTRL_B / $ cliset -t fan -d simubad -v 0 1 2 1  
    simu fan bad successfully!

System Response

None

Translation
Download
Updated: 2019-07-12

Document ID: EDOC1000138381

Views: 701349

Downloads: 36

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next