No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 2800 V3 V300R006

This document is applicable to OceanStor 2800 V3. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change remote_device transport_optimize

change remote_device transport_optimize

Function

The change remote_device transport_optimize command is used to configure the function of optimizing iSCSI link transmission.

Format

change remote_device transport_optimize remote_device_id=? optimize_enabled=?

Parameters

Parameter

Description

Value

remote_device_id=?

Remote device ID.

To obtain the value, run "show remote_device general".

optimize_enabled=?

Whether the function of optimizing iSCSI link transmission is enabled or disabled.

The value can be "yes" or "no", where:

  • "yes": enables the function of optimizing iSCSI link transmission.
  • "no": disables the function of optimizing iSCSI link transmission.

Views

Developer view

Usage Guidelines

  • Do not use this command without R&D engineers' guidance.
  • Executing the command may cause link reconnection that interrupts services.
  • This command is invalid for interface cards using TCP offload engine(TOE) function.
  • This command is applicable to the scenario where the network latency is larger than 5 ms and smaller than 200 ms and the packet loss rate is smaller than 5%. It is recommended to deploy the replication link in parallel networking mode.

Example

Enable the function of optimizing iSCSI link transmission for the remote device whose ID is "0".

developer:/>change remote_device transport_optimize remote_device_id=0 optimize_enabled=yes 
WARNING: You are about to configure the function of optimizing transmission for remote devices. This operation may cause the iSCSI link to reconnect and interrupt services. 
Suggestion: Before performing this operation, confirm that multiple replication links are normally connected. 
Have you read warning message carefully?(y/n)y 
Are you sure you really want to perform the operation?(y/n)y 
Command executed successfully.

System Response

None

Translation
Download
Updated: 2019-03-30

Document ID: EDOC1000138381

Views: 548861

Downloads: 35

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next