No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

OceanStor 2800 V3 V300R006

This document is applicable to OceanStor 2800 V3. Based on the CLI provided by the DeviceManager, this document describes how to use variouscommands classified by functions and how to set the CLI and manage the storage system throughthese commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
create lun_migration

create lun_migration


The create lun_migration command is used to create a LUN migration.


create lun_migration source_lun_id=? target_lun_id=? [ speed=? ] [ work_mode=? ]






ID of a source LUN.

Run the "show lun general" command without parameters to obtain the value.


ID of a target LUN.

Run the "show lun general" command without parameters to obtain the value.


Data migration speed of a LUN.

The value can be Low, Middle, High, Highest, and the default value is Middle.


Split mode of a LUN migration.

The value can be Auto, Manual, and the default value is Auto.



Usage Guidelines



To create LUN migration, run the following command.

admin:/>create lun_migration source_lun_id=5 target_lun_id=7  
WARNING: You are about to create a migration relationship between source LUN and target LUN. Migration starts immediately after the relationship is established, and the data on the target LUN will be overwritten by that on the source LUN after the migration. 
Suggestion: Before performing this operation, ensure that the selected source LUN and target LUN are correct and the target LUN is not being read or written by hosts.If the capacity of the target LUN is larger than that of the source LUN, scan for the source LUN again after the migration is complete. 
Have you read warning message carefully?(y/n)Y 
Are you sure you really want to perform the operation?(y/n)Y 
Command executed successfully.

System Response


Updated: 2019-07-12

Document ID: EDOC1000138382

Views: 317751

Downloads: 38

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next