No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 18000 V3 Series V300R006

This document is applicable to OceanStor 18500 V3 and 18800 V3. Based on the CLI, this document describes how to use various commands classified by functionsand how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change system cache

change system cache

Function

The change system cache command is used to set the cache's high and low watermarks. After the high and low watermarks are set, the storage system synchronizes the dirty data from the cache to hard disks based on the settings.

Format

change system cache { high_water_level=? | low_water_level=? } *

Parameters

Parameter

Description

Value

high_water_level=?

Percentage of the high watermark.

The value is an integer ranging from 2 to 90.

low_water_level=?

Percentage of the low watermark.

The value is an integer ranging from 1 to 80.

Views

Developer view

Usage Guidelines

  • If the watermarks are set improperly, system performance may be affected.
  • Before running this command, ensure that the watermarks are set properly. It is recommended that the percentage of the low watermark range from 20 to 40 and that of the high watermark range from 70 to 90.
  • The percentage of the high watermark must be greater than that of the low watermark.

Example

To set the percentage of the high watermark to "80%" and that of the low watermark to "30%", run the following command.

developer:/>change system cache high_water_level=80 low_water_level=30 
Command executed successfully.

System Response

None

Translation
Download
Updated: 2019-07-12

Document ID: EDOC1000138389

Views: 488333

Downloads: 85

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next