No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Advanced O&M Command Reference

OceanStor 18000 V3 Series V300R006

This document is applicable to OceanStor 18500 V3 and 18800 V3. Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
xnet showethsendq

xnet showethsendq

Function

The xnet showethsendq command is used to query information about messages in the current eth sending queue.

Format

xnet showethsendq { -c controller -p pid | -a } [ -f ]

Parameters

Parameter

Description

Value

controller

Controller ID.

The value ranges from 0 to the number of controllers minus one.

pid

Module ID.

The value ranges from 0 to 1023.

-a

Collects statistics on messages corresponding to all PIDs.

-

-f

Prints message information in the queue to the message log.

-

Views

Diagnostic view

Usage Guidelines

  • This command is used to query a specified controller or module, or messages of all controllers in the current eth sending queue.
  • This command is used by development engineers to locate faults.

Example

  • Query information about messages of module "47" of controller "1" in the current eth sending queue.
    admin:/diagnose>xnet showethsendq -c 1 -p 47 
    controller(1) pid(47) sendq msg: 0 
     
  • Query information about messages of module "47" of controller "1" in the current eth sending queue and print the information to the message log.
    admin:/diagnose>xnet showethsendq -c 1 -p 47 -f 
    controller(1) pid(47) sendq msg: 0
  • Query information about messages of all controllers in the current eth sending queue.
    admin:/diagnose>xnet showethsendq -a 
    controller(1) sendq msg: 0 
    controller(2) sendq msg: 0 
    controller(3) sendq msg: 0 
    controller(4) sendq msg: 0 
    ...

System Response

The following table describes the parameter meanings.

Parameter

Meaning

controller

Controller ID.

pid

Module ID.

sendq msg

Number of messages in the sending queue.

Translation
Download
Updated: 2019-07-12

Document ID: EDOC1000138389

Views: 502235

Downloads: 85

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next