No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Command Reference

OceanStor 18000 V3 Series V300R006

This document is applicable to OceanStor 18500 V3 and 18800 V3. Based on the CLI provided by DeviceManager, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change user_mode current_mode

change user_mode current_mode


The change user_mode current_mode command is used to switch a user view. This command is used when you want to switch from the user view to the developer, or engineer view.


change user_mode current_mode user_mode=?






View that you want to enter.

The value can be "developer" or "engineer",where:

  • "developer": developer view.
  • "engineer": engineer view.

If the error message (^) is displayed after entering "developer" or "engineer" and pressing Tab or Enter button, the switch to the enter view is not supported.



Usage Guidelines



  • Enter the developer view.
    admin:/>change user_mode current_mode user_mode=developer 
    DANGER: You are about to switch to the developer view. Commands in this view must be run under the guidance of R&D engineers. You can choose whether to run this command. If you run this command to switch to the developer view, it means that you know risks of running commands in the developer view. Device vendors are not responsible for any loss or damage caused to the user or others by running commands in the developer view. 
    1. Running the command in the developer view may cause system reset, restart, offline, service interruption, data loss, and data inconsistency. 
    2. Running the command in the developer view may cause the performance to decrease. 
    3. Running the command in the developer view to delete or remove configurations may have impact on the service and data. 
    4. Running the command in the developer view may cause system alarms. 
    Suggestion: Run this command under the guidance of R&D engineers. 
    Have you read danger alert message carefully?(y/n)y 
    Are you sure you really want to perform the operation?(y/n)y 
  • Enter engineer view.
    admin:/>change user_mode current_mode user_mode=engineer  

System Response


Updated: 2019-07-12

Document ID: EDOC1000138390

Views: 237695

Downloads: 150

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next