No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 2000, 5000, and 6000 V3 Series V300R006

This document is applicable to OceanStor 2200 V3, 2600 V3 Video Surveillance Edition, 2600 V3, 5300 V3, 5500 V3, 5600 V3, 5800 V3, and 6800 V3. Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change repair configuration

change repair configuration


The change repair configuration command is used to configure the current bad sector repair function.


change repair configuration [ enabled=? ] [ verify_period=? ] [ verify_times=? ]






Whether to enable bad sector repair.

The value can be "yes" or "no", where:

  • "yes": to enable bad sector repair.
  • "no": not to enable bad sector repair.


Cycle of enabling bad sector repair.

The value ranges between "0" and "600", expressed in seconds.


Number of times to enable bad sector repair.

The value ranges between "0" and "30".


Developer view

Usage Guidelines



To configure the current bad sector repair function, run the following command:

developer:/>change repair configuration enabled=yes verify_period=100 verify_times=6 
WARNING: You are going to adjust bad sector repair parameters. The bad sector repair parameters include bad sector verification period and times. If the times of the periodical verification failure reaches the set value, the disk containing the bad sector is failing. 
Suggestion: Perform this operation based on system reliability need. 
Have you read warning message carefully?(y/n)y 
Are you sure you really want to perform the operation?(y/n)y 
Command executed successfully. 

System Response


Updated: 2019-07-12

Document ID: EDOC1000138402

Views: 631070

Downloads: 703

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next