No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Advanced O&M Command Reference

OceanStor 2000, 5000, and 6000 V3 Series V300R006

This document is applicable to OceanStor 2200 V3, 2600 V3 Video Surveillance Edition, 2600 V3, 5300 V3, 5500 V3, 5600 V3, 5800 V3, and 6800 V3. Based on the CLI, this document describes how to use various commands classified by functions and how to set the CLI and manage the storage system through these commands. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
change lun_takeover finish_switch_path

change lun_takeover finish_switch_path


The change lun_takeover finish_switch_path command is used to confirm that the host paths of the specified LUN have been switched to the paths between the host and the target disk array.


change lun_takeover finish_switch_path lun_id=?







To obtain the value, run "show lun_takeover general".


Developer view, Engineer view

Usage Guidelines



Confirm that the host paths of the specified LUN have been switched to the paths between the host and the target storage array.

engineer:/>change lun_takeover finish_switch_path lun_id=0 
DANGER: You are about to switch over the LUN paths. This operation may cause data loss. 
Suggestion: Before performing this operation, confirm that the host path of the LUN has been switched to the target array. 
Have you read danger alert message carefully?(y/n)y 
Are you sure you really want to perform the operation?(y/n)y 
Command executed successfully.

System Response


Updated: 2019-07-12

Document ID: EDOC1000138402

Views: 633172

Downloads: 705

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next