No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Parts Replacement

OceanStor 2800 V3 V300R006

This document is applicable to OceanStor 2800 V3. This document describes the procedure for replacing the parts of the storage system in terms of safety operations, preparations, and precautions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing a Mini SAS HD Cable

Replacing a Mini SAS HD Cable

This section describes how to replace a mini SAS cable.

Impact on the System

When a mini SAS HD cable is being replaced, services on this cable are interrupted. Perform this operation with caution.

Prerequisites

  • A spare part is on hand.
  • You have located the component that houses the mini SAS HD cable you want to replace.
NOTE:

You can locate a component in either of the following ways:

  • Log in to DeviceManager and go to the System page. On the System page, check the device view and locate the position of the component to be replaced. If the component has a Location indicator, turn on the indicator. (For details about how to turn on a Location indicator, see the online help of DeviceManager.)
  • Use the Alarm indicator of the component to locate its position.
  • Data has been backed up before you replace the cable online.

Precautions

Use even force when you remove or insert a mini SAS HD cable. Excessive force may damage the appearance or connector of the mini SAS HD cable.

Tools and Materials

  • ESD wrist strap
  • ESD bags
  • Labels

Procedure

  1. Wear an ESD wrist strap.
  2. Hold the mini SAS HD cable and push the connector slightly inward, as shown in Figure 6-40.

    Figure 6-40 Pushing the cable connector inward

  3. Hold the plastic ring and pull it outward along the arrow direction until the mini SAS HD cable is unlocked, as shown in Figure 6-41 and Figure 6-42.

    Figure 6-41 Top view of removing a mini SAS HD cable

    Figure 6-42 Bottom view of removing a mini SAS HD cable

  4. Pull the mini SAS HD cable connector out of the port and put it in to an ESD bag.
  5. Take the spare part out of the ESD bag.
  6. Insert the spare part vertically into the corresponding position, as shown in Figure 6-43.

    Figure 6-43 Connecting a mini SAS HD cable

  7. View the Port indicator, and determine whether the cable has been successfully installed.

    • If the indicator is steady green or blue, the cable has been successfully installed.
    • If the indicator is steady red or off, the newly installed cable is faulty, the cable slot is faulty, or the cable is incorrectly installed.

Follow-up Procedure

After the mini SAS HD cable is replaced, label it to facilitate subsequent operations.

Translation
Download
Updated: 2019-08-30

Document ID: EDOC1000138807

Views: 21990

Downloads: 21

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next