Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an L2TP VPN Connection
Configuring L2TP VPN
- Enter 1 to create a connection.
- Enter 2 and set the VPN type to L2TP/IPSec.
- Enter the corresponding sequence number to complete the configuration of parameters 1 to 8.
- 1. Connection Name(Required)
- 2. Description
- 3. LNS Server Address(Required)
- 4. Tunnel Name(Required)
- 5. Authentication Mode
- 6. Tunnel Authentication: Enable the tunnel authentication function. After the tunnel authentication function is enabled, you need to enter the tunnel authentication password.
- 7. IPSec Protocol: Enable the IPSec protocol. Do not enable this function.
- 8. Allow Internet access after connection: Set routes. After this option is enabled, you can set the traffic to be encrypted in the VPN tunnel by adding an IP address segment.
- Enter 9 to save the configuration.
Establishing an L2TP VPN Connection
- Enter the corresponding number to establish an L2TP VPN connection.
- Enter 1 to set up an L2TP VPN connection.
- Enter the user name and password to log in.
After the connection is successful, do not close the terminal window. Otherwise, the connection will be disconnected.
L2TP VPN Disconnection
Enter q to cut off the connection.
