No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Event Reference

OceanStor Dorado V3 Series V300R001

This document is applicable to OceanStor Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. This document describes the basic knowledge about the events of storage system in terms of event definition, event level, impact on the system, possible cause, and handling procedure. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
0xF00060007 Link Between Network Ports Is Abnormal

0xF00060007 Link Between Network Ports Is Abnormal

Description

The link between the two network ports is abnormal.

Applicable Model

Applicable to all models.

Attribute

ID

Event Level

Automatically Cleared

0xF00060007

Major

No

Impact on the System

  • Storage devices cannot be managed.
  • System reliability decreases.

Possible Causes

  • Network port cables are incorrectly connected.
  • Network port cables are removed or damaged.

Procedure

  1. Check whether network port cables are incorrectly connected.

    1. Check whether network cables are connected as shown in the standard network diagram in the user manual. If the cables are not correctly connected, connect them again. If the alarm persists after the cables are reconnected=> Step2.

  2. Check whether network cables are removed or damaged.

    1. If the cables are removed, reinsert the cables. If the alarm persists after the cables are reinserted=> 2.2.
    2. If the cables are damaged, replace the cables. If the alarm persists after the cables are replaced=> Step3.

  3. Contact technical support engineers.
Translation
Download
Updated: 2018-10-19

Document ID: EDOC1000141827

Views: 88015

Downloads: 170

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next