Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
0xF0060011 Network Port Is Working In Half-Duplex Mode
Description
A network port is working in half-duplex mode.
Applicable Model
Applicable to all models.
Attribute
ID |
Event Level |
Automatically Cleared |
|---|---|---|
0xF0060011 |
Major |
Yes |
Impact on the System
The interface module where the port resides cannot provide services.
Possible Causes
- The peer host or peer switch where the network port resides supports only half-duplex.
- Cables are not firmly inserted into their slots or damaged.
- Network port components are faulty.
Procedure
- Check the working mode of the peer port.
- If the peer port is working in half-duplex mode, change the working mode to full-duplex. If the alarm persists=> 1.2.
- If the peer port supports only half-duplex mode, adjust network connections to ensure that full-duplex is supported. If the alarm persists=> Step2.
- If the peer port meets requirements=> Step2.
- Check cables.
- If any cable is not firmly inserted into its slot, reinsert it. If the alarm persists=> 2.2.
- Replace the faulty cable. If the alarm persists=> Step3.
- Replace the module where the network port resides. If the alarm persists=> Step4.
- Collect related information and contact technical support engineers.
Previous
