No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Event Reference

OceanStor Dorado V3 Series V300R001

This document is applicable to OceanStor Dorado5000 V3, Dorado6000 V3 and Dorado18000 V3. This document describes the basic knowledge about the events of storage system in terms of event definition, event level, impact on the system, possible cause, and handling procedure. The document that you browse online matches the latest C version of the product. Click Download to download documents of other C versions.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
0xF01070015 Failed To Add Remote Replication To A Consistent Group

0xF01070015 Failed To Add Remote Replication To A Consistent Group


Adding remote replication to a consistent group fails.

Applicable Model

Applicable to all models.



Event Level

Automatically Cleared




Impact on the System

Remote replication fails to be added to a consistent group.

Possible Causes

When remote replication is added to a consistent group in delayed mode, a fault occurs, such as disk failure, link disconnection, and controller reset.


  1. Check whether an alarm is reported, such as disk failure, link disconnection, and controller reset.

    1. If yes, rectify the fault, and then manually add the remote replication consistency group again.
    2. If no=> Step2.

  2. After you run the command for adding remote replication to the consistency group in delayed mode, confirm whether any operation is performed on remote replication and the consistency group.

    1. If yes, manually add remote replication to the consistency group again based on the latest configurations.
    2. If no=> Step3.

  3. Confirm whether the number of members in the consistency group reaches the upper limit.

    1. If yes, remove some members and then add them again, or add the members to other consistency groups.
    2. If no=> Step4.

  4. Collect related information and contact technical support engineers.
Updated: 2018-10-19

Document ID: EDOC1000141827

Views: 87489

Downloads: 169

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next