No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S600-E V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
OSPF_1.3.6.1.4.1.2011.5.25.155.31.3 hwOspfv2IntraAreaRouteridConflict

OSPF_1.3.6.1.4.1.2011.5.25.155.31.3 hwOspfv2IntraAreaRouteridConflict

Description

OSPF/2/RTRID_CONFLCT:OID [oid] Router IDs conflict in an intra area. (ProcessId=[integer], AreaId=[ipaddr], SelfIfnetIndex=[integer], NbrIpAddr=[ipaddr], RouterId=[ipaddr], NbrRtrId=[ipaddr])

Router IDs conflict in an intra-area.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.155.31.3 Major communicationsAlarm(2)

Parameters

Name Meaning

oid

Indicates the MIB object ID of the alarm.

ProcessId

Process ID

AreaId

Area ID

SelfIfnetIndex

Index of an interface

NbrIpAddr

IP address of a neighbor

RouterId

Local router ID

NbrRtrId

Router ID of a neighbor

Impact on the System

If the same router ID is configured for any two routers, it will cause the router lSA to be refreshed frequently. As a result, route flapping will occur.

Possible Causes

The same router ID was configured for at least two indirectly connected switch devices within one area, causing the router lSA to be refreshed frequently and route flapping.

Procedure

  1. Check whether the router ID in the alarm is the same as that of a neighbor.

    • If they are the same, go to Step 2.
    • If they are different, go to Step 4.

  2. Run the display current-configuration command to check whether the current configuration contains the undo ospf router-id auto-recover disable command.

    • If the current configuration contains the undo ospf router-id auto-recover disable command, go to Step 4.
    • If the current configuration does not contain the undo ospf router-id auto-recover disable command, go to Step 3.

  3. Run the undo ospf router-id auto-recover disable command to enable the automatic recovery function, and select a new router ID for a switch. Then, check whether the alarm is cleared.

    • If the alarm is cleared, go to Step 6.
    • If the alarm persists, go to Step 5.

  4. Run the ospf router-id router-id command to configure a new router ID for a switch. Run the command to restart the OSPF process. Then, check whether the alarm is cleared.

    • If the alarm is cleared, go to Step 6.
    • If the alarm persists, go to Step 5.

  5. Collect alarm information and configuration information, and then contact technical support personnel.
  6. End.

Related Information

None.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141873

Views: 113257

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next