No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

S600-E V200R010C00

This document provides the explanations, causes, and recommended actions of alarms on the product.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
SRM_1.3.6.1.4.1.2011.5.25.129.2.1.9 hwEntityInvalid 67861

SRM_1.3.6.1.4.1.2011.5.25.129.2.1.9 hwEntityInvalid 67861

Description

SRM/3/ENTITYINVALID:OID [OID] PHY chip abnormal. (EntityPhysicalIndex[INTEGER1], BaseTrapSeverity=[INTEGER2], BaseTrapProbableCause=[INTEGER3], BaseTrapEventType=[INTEGER4], EntPhysicalContainedIn=[INTEGER5], EntPhysicalName=[OCTET1], RelativeResource=[OCTET2], ReasonDescription=[OCTET3])

This alarm was generated when the chip was detected abnormal.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.129.2.1.9 Minor equipmentAlarm(5)

Parameters

Name Meaning
OID OID of the MIB
EntityPhysicalIndex Entity index
BaseTrapSeverity Severity code
BaseTrapProbableCause Error code
BaseTrapEventType Code of the event type
EntPhysicalContainedIn Entity code
EntPhysicalName Entity name
RelativeResource Name of the affected component
ReasonDescription Fault description

Impact on the System

The services on the interface corresponding to the faulty PHY chip are interrupted.

Possible Causes

The PHY chip was faulty.

Procedure

  1. If the interface corresponding to the faulty PHY chip is Up, the device automatically resets. Then, you need to check whether the interface sends and receives packets normally.

    (1) If not, it indicates that the PHY chip is faulty. In this case, you need to replace the device.

    (2) If so, go to Step 4.

  2. If the interface corresponding to the faulty PHY chip is Down, the device does not reset automatically.

    (1) If you do not use the interface, no action is required.

    (2) If you need to use the interface, go to Step 3.

  3. Run the reboot command to reset the device, and then check whether the interface sends and receives packets normally.

    (1) If not, it indicates that the PHY chip is faulty. In this case, you need to replace the device.

    (2) If so, go to Step 4.

  4. End.

Related Information

None.

Translation
Download
Updated: 2019-04-18

Document ID: EDOC1000141873

Views: 125561

Downloads: 14

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next